Investigation on Heat Transfer Augmentation in a Inner-Cooling Passage with Triangular V-Shaped and Inverse V-Shaped Ribs

doi:10.13675/j.cnki. tjjs. 180710

Journal of Propulsion Technology ›› 2019, Vol. 40 ›› Issue (9): 2040-2049.DOI: 10.13675/j.cnki. tjjs. 180710

Previous Articles Next Articles

Investigation on Heat Transfer Augmentation in a Inner-Cooling Passage with Triangular V-Shaped and Inverse V-Shaped Ribs

1.College of Aircraft Traffic Management,Civil Aviation University of China,Tianjin 300300，China;2.Shanghai Aerospace System Engineering Institute,Shanghai 201108，China;3.College of Aeronautical Mechanics Engineering,Civil Aviation University of China,Tianjin 300300，China

Published:2021-08-15

带三角形V肋和反向V肋内冷通道强化换热机理研究

刘聪¹,王钊²,张宗卫³

1.中国民航大学空管学院，天津 300300;2.上海宇航系统工程研究所，上海 201108;3.中国民航大学航空工程学院，天津;300300

作者简介:刘聪，博士，讲师，研究领域为飞行器高温部件热防护技术。E-mail：liucongcauc@163.com
基金资助:
中央高校基本科研业务费中国民航大学专项 3122018C034;中国民航大学科研启动基金项目 2017QD06S中央高校基本科研业务费中国民航大学专项（3122018C034）；中国民航大学科研启动基金项目（2017QD06S）。

Abstract

Abstract: In order to investigate the effects of V-shaped rib arrangement and the shape of their section on heat transfer and flow structure near the ribbed channel surface, the distribution of heat transfer coefficient of V-shaped and inverse V-shaped ribs with triangular section shape at different Reynolds number conditions are studied experimentally using transient liquid crystal technique and CFD. The development characteristics of vortex induced by V-shaped and inverse V-shaped ribs are analyzed using numerical simulation. These results are also compared with that of traditional rectangular ribs. Results show that the heat transfer coefficient on ribbed channel surface increases with the increase of Reynolds number. The heat transfer coefficient distribute with a shape of “heart” behind the V-shaped ribs, and a pair of vortex are induced between the two branches of every rib, and develop laterally along the flow direction. The high heat transfer area of triangular ribs is more concentrated to the middle line than rectangular ribs. The heat transfer coefficient distribute with a shape of chinese word “eight” behind the inverse V-shaped ribs, and a pair of vortex are induced outside the two branches of every rib and develop to the middle line. The vortexes induced by triangular ribs have a wider lateral range. Thus the heat transfer of triangular ribs is stronger than that of rectangular ribs and the triangular inverse V-shaped ribs perform better when the inlet Reynolds number is below 2.5×10⁴.

Key words: Triangular rib;V-shaped rib;Inverse V-shaped rib;Heat transfer coefficient;Induced vortex

摘要： 为了研究V型肋分布形式和截面形状对带肋通道表面的换热强度和流动结构的影响，采用瞬态液晶实验和数值模拟相结合的方法，对截面形状为三角形的V肋和反向V肋在不同雷诺数工况下的表面换热系数分布规律进行了研究，并分析了V肋和反向V肋诱导产生的肋间涡的发展特性，并与传统矩形截面肋结构进行了对比分析。结果表明：带肋通道表面换热系数随雷诺数增大而增大；正向V肋后换热系数呈“心”型分布，在一条肋两支之间诱导一对涡，并沿流向向两侧发展，三角形截面肋的高换热区更集中于中线；反向V肋后换热系数呈“八”字型分布，在一条肋两支外侧诱导对涡，沿流向向中间发展，且三角形肋的展向范围更大。三角形截面肋的换热强于矩形截面肋，且当入口雷诺数低于2.5×10⁴时，三角形反向V肋的换热效果最好。

关键词: 三角形肋;V肋;反向V肋;换热系数;诱导涡

LIU Cong¹,WANG Zhao²,ZHANG Zong-wei³. Investigation on Heat Transfer Augmentation in a Inner-Cooling Passage with Triangular V-Shaped and Inverse V-Shaped Ribs[J]. Journal of Propulsion Technology, 2019, 40(9): 2040-2049.

刘聪,王钊,张宗卫. 带三角形V肋和反向V肋内冷通道强化换热机理研究[J]. 推进技术, 2019, 40(9): 2040-2049.

References

[1] Han J C, Park J S. Developing Heat Transfer in Rectangular Channels with Rib Turbulators[J]. International Journal of Heat and Mass Transfer， 1988， 31(1): 183-195.
[2] Han J C， OU S， Park J S， et al. Augmented Heat Transfer in Rectangular Channels of Narrow Aspect Ratios with Rib Turbulators[J]. International Journal of Heat and Mass Transfer， 1989， 32 (9): 1619-1630.
[3] Han J C. Heat Transfer and Friction Characteristics in Rectangular Channels with Rib Turbulators[J]. Journal of Heat Transfer， 1988， 110 (2): 321-328.
[4] Park J S， Han J C， Huang Y， et al. Heat Transfer Performance Comparisons of Five Different Rectangular Channels with Parallel Angled Ribs[J]. International Journal of Heat and Mass Transfer， 1992， 35(11): 2891-2903.
[5] Liu Y H， Wright L M， Fu W L， et al. Rib Spacing Effect on Heat Transfer in Rotating Two-Pass Ribbed Channel[J]. Journal Thermophysics and Heat Transfer， 2007， 21(3)： 582-595.
[6] Smith M A， Mathison R， Dunn M G. Heat Transfer for High Aspect Ratio Rectangular Channels in a Stationary Serpentine Passage with Turbulated and Smooth Surfaces[R]. ASME GT2013-94924.
[7] Han J C， Zhang Y M， and Lee C P. Augmented Heat Transfer in Square Channels with Parallel， Crossed and V-Shaped Angled Ribs[J]. Journal of Heat Transfer， 1991， 113（4）: 590-596.
[8] Han J C， Huang J J， Lee C P. Augmented Heat Transfer in Square Channels with Wedge-Shaped and Delta-Shaped Turbulence Promoters[J]. Journal of Enhanced Heat Transfer， 1993，（1）: 37-52.
[9] Bhagoria J L， Saini J S， Solanki S C. Heat Transfer Coefficient and Friction Factor Correlations for Rectangular Solar Air Heater Duct Having Transverse Wedge Shaped Rib Roughness on the Absorber Plate[J]. International Journal of Renewable Energy， 2002， 25: 341-369.
[10] Aharwal K R， Gandhi B K， Saini J S. Heat Transfer and Friction Characteristics of Solar Air Heater Ducts Having Integral Inclined Discrete Ribs on Absorber Plate[J]. International Journal of Heat and Mass Transfer， 2009， 52（25）: 5970-5977.
[11] Maurer M， Von Wolfersdorf J， Gritsch M. An Experimental and Numerical Study of Heat Transfer and Pressure Loss in a Rectangular Channel with V-Shaped Ribs[R]. ASME GT2006-90006.
[12] Wright L M， Fu W L， Han J C. Thermal Performance of Angled， V-Shaped， and W-Shaped Rib Turbulators in Rotating Rectangular Cooling Channels (AR=4:1)[R]. ASME GT2004-54073.
[13] Han J C， Zhang Y M. High Performance Heat Transfer Ducts with Parallel and V-Shaped Broken Ribs[J]. International Journal of Heat and Mass Transfer， 1992， 35 (2): 513-523.
[14] Tanda G. Heat Transfer in Rectangular Channels with Transverse and V-Shaped Broken Ribs[J]. International Journal of Heat and Mass Transfer， 2004， 47: 229-243.
[15] Kan Rui， Yang Li， Ren Jing， et al. Effect of Rib Configuration and Lateral Ejection on a High Aspect Ratio Trailing Edge Channel[R]. ASME GT2013-94549.
[16] 阚瑞，陈伟，任静，等. 梯形带肋内部冷却通道的流动及传热特性实验[J]. 工程热物理学报， 2010， 31(5): 753-756.
[17] 陈伟，阚瑞，任静，等. 涡轮叶片内部冷却通道传热和压力分布特性的实验[J]. 航空动力学报， 2010， 25(12): 2780-2786.
[18] 迟重燃，任静，蒋洪德. 燃机叶片平行肋扰流内冷通道传热特性研究（Part Ⅰ）: 流动传热机理[J]. 工程热物理学报， 2013， 34(4): 624-627.
[19] 迟重燃，任静，蒋洪德. 燃机叶片平行肋扰流内冷通道传热特性研究（Part Ⅱ）: 耦合传热特性[J]. 工程热物理学报， 2014， 35(1): 42-45.
[20] 王德强，饶宇，张鹏，等. 涡轮叶片内冷通道高性能肋流动与传热[J]. 工程热物理学报， 2018， 39(1): 55-61.
[21] 周明轩，薛树林，贺宜红，等. 高阻塞比肋化通道对流换热特性实验研究[J]. 推进技术， 2018， 39(2): 335-341.
[22] 冯晓星，田淑青，邓宏武，等. 高旋转数下直肋U型方通道的换热特性研究[J]. 推进技术， 2016， 37(3):428-435.
[23] 朱强华，崔苗，高效伟. 肋开孔高度对大宽高比矩形通道流动传热的影响[J]. 推进技术， 2014， 35(12):1630-1638.
[24] Xie G， Liu J， Ligrani P M， et al. Numerical Analysis of Flow Structure and Heat Transfer Characteristics in Square Channels with Different Internal-Protruded Dimple Geometrics[J]. International Journal of Heat and Mass Transfer， 2013， 36（1）: 81-97.
[25] Ligrani P M， Mahmood G I， Harrison J l， et al. Flow Structure and Local Nusselt Number Variations in a Channel with Dimples and Protrusions on Opposite Walls[J]. International Journal of Heat and Mass Transfer， 2001， 44(23): 4413-4425.
[26] Xie G， Sunden B， Zhang W. Comparisons of Pins/Dimples/Protrusions Cooling Concepts for a Turbine Blade Tip-Wall at High Reynolds Numbers[J]. Journal of Heat Transfer， 2011， 133(6).
[27] Chang S W， liou T M， Lee T H. Thermal Performance Comparison Between Radially Rotating Ribbed Parallelogram Channels with and Without Dimples [J]. International Journal of Heat and Mass Transfer， 2012， 55(13): 3541-3559.
[28] Choi E Y， Choi Y D， Lee W S， et al. Heat Transfer Augmentation Using a Rib-Dimple Compound Cooling Technique[J]. Applied Thermal Engineering， 2013， 51(1): 435-441.
[29] Ekkad S V， Han J. A Transient Liquid Crystal Thermography Technique for Gas Turbine Heat Transfer Measurements[J]. Measurement Science and Technology， 2000， 11(7): 957-968.
[30] Yan Y， Owen J M. Uncertainties in Transient Heat Transfer Measurements with Liquid Crystal [J]. International Journal of Heat and Fluid Flow， 2002， 23: 29-35.

Investigation on Heat Transfer Augmentation in a Inner-Cooling Passage with Triangular V-Shaped and Inverse V-Shaped Ribs

带三角形V肋和反向V肋内冷通道强化换热机理研究

PDF

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 0

Recommended Articles

Metrics

Comments